Windows Knowledge Base

[Clariion]Clariion SP Error Code Explained - Part Two- SOFT CODES

SOFT CODES

These codes are also known as threshold codes.

0x801, Soft SCSI Error:
This code indicates that an abnormal SCSI bus or disk drive event was detected.     A retry of the
operation cleared the condition.

0x802, Illegal SCSI Bus Interrupt:
An inconsistent interrupt situation has been detected on the SP.

0x803, Recommend Disk Replacement:
This disk CRU has sent    status to the SP indicating that it believes it may be susceptible    to a fault
in the    near future.  We recommend replacing the drive.

0x804, Single Bit Error:
The SP's tolerance level for single bit errors    in the write stache has been exceeded.

0x805, Single Bit Error:
The SP's tolerance level for single bit errors    in the read stache has been exceeded.

0x820, Soft Media Error:
The disk CRU has reported a media defect which    was successfully cleared be the SP.

0x840, Disk Sector    Invalidated:
The LUN that owns this    disk CRU encountered a condition which required the firmware to
invalidate a sector on    the unit.  The firmware    did this to ensure    that incorrect data is not returned
to the    host in    the future.

0x850, Enclosure State Change:
The SP    has detected that an enclosure has changed state.

0x851, Enclosure Address Error:
The SP    has detected that an enclosure has an invalid address.  Enclosure chain shunted prior to
failing enclosure.

0x852, Enclosure Duplicate Address Error:
The SP    has detected that two or more enclosures have the same address.    Enclosure chain    shunted
prior to failing enclosure.